WebGate MH1600M Guide d'installation télécharger pdf (Page 118)

Installaction & User Manual

118

Edition

Select Schedule to edit and change weekday, program,time directly.

In case that Schedule 50 are all configured, select the time zone to change by mouse click and

click the time again, previouse configuartion will be deleted and new configuration will be shown.

Caution : If selecting the same time twice, “!” will be shown on the chart.

When configuring time sector, previously configured time can not be included.

6.6.2.3 Event recording setup

Select resolution and frame rate and quality for event recording.

There are 4 triggers – Sensor, Motion detection, Text, Digital input.

First, select the program and check resolution and frame rate and quality of the channel.

(Refer to 6.6.1, program configuration)

Event recording can sync manual&event, Scheduel&Event.

Select among Manual&Event, Schedule&Event in “Recording mode” of [Record configuration]-

[recording].

Reference : Please, check below to configure event recording.

1. Select one of Manual&Event, Schedule&Event.

2. In program configuration, set frame rate by 0 fps in general mode and only

configure Event frame rate.

3. Set Event applying time.

Event Time configuration

Configure time for event recording and there are 3 modes – Always, no use, Custom.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 188 189

Pas de commentaire

WebGate MH1600M Guide d'installation Page 118